hello@metartmesh.com +86 158 0318 7372 / +61 435 598 786

Antique Copper Designer Wire Mesh for Furniture-METART-WW20

Specification

Raw Material: Stainless Steel 201, 304 , or 316

Mesh Type: Rigid Architectural Mesh

Opening Area:59%

Estimated Square Meter Weight: Approx 3.4kg/㎡

Finish: Antique Copper Plating

Sheet Width: Custom made

Sheet Length: Custom made

GET A QUOTE

Introduction

Wire mesh pattern METART WW20 has an aged copper-plated finish in this instance.

But take note that the strips and wire used to make this wire mesh are composed of stainless steel.

This pattern is uncomplicated and lightweight because it uses 1.45mm wires for the warp and 4x1mm wire strips for the weft.

Although this architectural woven wire mesh is stiff, it is not sturdy enough for application scenarios where security is essential.

However, it is reasonably priced and appropriate for architectural partition screens, office dividing screens, living room metal screen divider infill panels, kitchen cabinet insert mesh, closet door metal grilles, cupboard door replacement wire mesh, wine bar cabinets mesh grille mesh, wine bar finishing wire mesh, wall cladding mesh panels, etc.


Specifications Table.

Raw Material

Stainless Steel Grade 201, 304, 316

Mesh Type

Rigid Architectural Wire Mesh

Wire Strip(widthxthickness)

4x1mm

Pre-Crimped Wire Rod Diameter

1.45mm

Wire Strip Pitch

18.5mm

Wire Rod Pitch

5.7mm

Wire Rod Group Pitch

23

Overall thickness of the fabric

2.9mm

Opening Area

59%

Privacy Rate

41%

Estimated Square Meter Weight

3.4kg/㎡

Finish

Antique Copper Finish

The way of cutting

Straight Cut

All optional ways of cut

Straight Cut Only

All optional Finishes

Mill Finish ( Original stainless steel bright finish),
Antique Bronze plating, Antique Copper plating, Antique brass plate, vacuum titanium plated, Painted, PVDF Coated,

Custom made specifications and Mini order accepted.

Note:

All the measurements including wire thickness, diameter, opening, and overall thickness are nominal numbers. The actual specification might have a tiny bit of tolerance according to fabrication

Application

GET A QUOTE

©COPYRIGHT METART BUILDING TEC CO., LTD  | ALL RIGHTS RESERVED | PRIVACY POLICY